Arduino Raspberry Pi GSM/GPRS/GNSS Bluetooth HAT Expansion Board GPS Module

Description

Arduino Raspberry Pi GSM/GPRS/GNSS Bluetooth HAT Expansion Board GPS Module SIM868 Compatible With Raspberry Pi 2B 3B Zero Zero W Support Make a Call,Send Messagess,DataTransfer IOT
Main Features:
ARDUINO , Raspberry Pi:Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
PACKAGE CONTENT 6 PCs: GSM/GPRS/GNSS HAT x1, GSM Antenna x1, GPS External Antenna (B) x1,Bluetooth Antenna x1,USB type A plug to micro plug cable x1,RPi screws pack (2pcs) x1
Support GPS, COMPASS, Glonass, LBS base station positioning, omni-positioning
Supports SMS, phone call, GPRS, DTMF, HTTP, FTP, MMS, email, etc.
AFTER SALE SUPPORT: get tehcnical support from waveshare when you buy from IOT electronics
Description
GSM/GPRS/GNSS/Bluetooth HAT for Raspberry Pi, Based on SIM868
This is a handy, low power Raspberry Pi HAT which features multi communication functionalities: GSM, GPRS, GNSS and Bluetooth.
It allows your Pi to easily make a telephone call, send messages, connect to wireless Internet, global position, transfer data via
Bluetooth, and so on.
Features
Raspberry Pi connectivity, compatible with Raspberry Pi 2B/3B/3B+/Zero/Zero W
Supports SMS, phone call, GPRS, DTMF, HTTP, FTP, MMS, email, etc.
Support GPS, COMPASS, Glonass, LBS base station positioning, omni-positioning
Bluetooth 3.0, supports data transferring through Bluetooth
Onboard USB TO UART converter CP2102 for UART debugging
6x LEDs for indicating the module working status
SIM card slot for 1.8V/3V SIM card
RTC with backup battery holder
Baudrate auto detection (1200bps ~115200bps)
Control via AT commands (3GPP TS 27.007, 27.005, and SIMCOM enhanced AT Commands)
Supports SIM application toolkit: GSM 11.14 Release 99
Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
SIM868 module
ZMM5V1: regulator diode
SMF05C: TVS diode
CP2102: USB TO UART converter
MP1482: power chip
NDC7002N: voltage level translator
GPS status indicator
NET indicator:
flashes fast when the module starts up
flashes slowly after GSM register succeed
STA module working status indicator
SIM868 UART Tx/Rx indicator
Power indicator
SIM868 control button: press the button and hold for 1s, to startup/shutdown the SIM868
Raspberry Pi GPIO connector
SIM card slot
USB TO UART interface
3.5mm earphone/mic jack
GNSS antenna connector
Bluetooth antenna connector
GSM antenna connector
CR1220 battery holder: for RTC back
Development Resources
Wiki : https://drive.google.com/open?id=1TpS66RrYtkAR