Microchip PIC Ethernet Board with RS232 Interface

Description

Microchip PIC Ethernet Board with RS232 Interface
SBC45EC
Ethernet Board & Web Server for Microchip PIC microcontrollers
Revision 2
The SBC45EC is a single board computer with 10 Mbs Ethernet and an RS232 interface for 44-pin PLCC PIC18Fxxx microcontrollers. It comes with a PIC18F452 CPU, a 24LC256 EEPROM for web pages, and with a demo of a Web Server installed. By using a terminal program, the demo web page can be replaced by a custom one with no programming required.
Typical applications include HTTP web servers, mail clients, Ethernet to RS232 interface converter, Ethernet to RS485 interface converters, remote control via web server, or protocol bridge applications -- Ethernet to USART, CAN, I2C, SPI etc.
It has been tested with the PIC18F452 and
PIC18F458
44-pin PLCC PIC chips and the Microchip TCP/IP stack, but it also can be used with any other 44-pin PLCC PIC18 chips as long as there is enough Flash memory.
Microchip PIC Ethernet Board features
PIC18F452 CPU
24LC256 EEPROM with web server pre-installed
Red Power LED
Red Collision/Link LED
Green RX/Carrier Sense LED
Yellow Transmit LED
RS232 interface via 3-pin connector or Frontend board
2.1mm power connector for standard DC transformer
Wide operating voltage range from 7 to 30V.
In-Circuit Serial Programming (ICSP) Connector
Assembled with 10BaseT Ethernet and RS232 interface with +/- 15kV ESD protection.
Frontend connector for possible expansion.
Optional Add-On Front-End Boards
This PIC board can be expanded with the following optional add-on boards:
Front-End: 2x In, 2x Out, 2x Relay for PIC Boards (IOR44-222)
Front-End: 2x In, 4x Out, 1x Relay for PIC Boards (IOR44-241)
Front-End: 4x In, 2x Relay for PIC Boards (IOR44-42)
Front-End: Male 9-pin Sub-D Connector for PIC Boards (SER2S)
Front-End: RS485 Expansion for SBC45EC (BUS2S-485)
Front-End: CAN Expansion for PIC Boards (BUS2S-CAN)
Optional In-Circuit Serial Programming (ICSP) Adapters
PIC ICSP Board Connector to DIL Adapter Set
, In-Circuit Programming Adapter Set for connecting this PIC board's ICSP connector to out-of-circuit PIC chip programmers with a DIP/ZIF socket.
PIC ICSP Adapter, 6-pin Single Row to RJ12 and 2mm 2x4 Header
, In-Circuit Programming Adapter for connecting this PIC board's ICSP connector to the debuggers programmers with RJ12 jack or single row square post headers.
Documentation and Software
This PIC board does not ship with any documentation or software. Please download the documentation and software from the links provided below.
Download PIC Ethernet Board manual (PDF file, 383kB)
Web Server source code, V2.03 (ZIP file, 532kB)
Web Server Documentation V2.03 (PDF file, 49kB)
TCP/IP Stack Documentation V2.10 (PDF file, 243kB)
Optional RS232 cable
An optional 6-foot RS232 Cable is available. This cable has a 9-pin Sub-D female connector on one side and a 3-pin IDC plug on the other. The cable can be directly connected to the 3-pin IDC connector on the PIC Ethernet board. Please select the appropriate option below if you would like to buy this cable with your PIC Ethernet board.