*NEW* WiFi Deauther V1.5 OLED Pre Installed Hacking Tool Deauth Attacks ESP8266

Description

( 100%
Tested )
WiFi Deauther + Ready To Go +
1 BAT
+
0.96" OLED
+
Joystick
V 2.0.5
PRE-FLASHED
+ Ready To Go + No Setup + No Coding
Scan for Wi-Fi networks
and
connect
to
pwned
The password is
deauther
Once connected, you can open up your
browser
and go to
192.168.4.1
You can now scan for networks
Please use it as a pentesting device for testing purposes only.
Best of the Best !!
Brand new and high quality. Best
Design concept from the open source project NodeMCU
The development board
integrated 18650 charge and discharge system
,
comes with charge and discharge protection, while
integrating an OLED
and
five-way button
to facilitate the development.
This item operation and NodeMCU consistent, an increase of a programmable LED, you can use GPIO16 to control, display 8266 running status and other functions. Integrated OLED and five-way button, more convenient development
Five-way buttons are controlled by FLATH, RSET, D5, D6, D7, respectively
OLED SDA and SCL, respectively, received D1 feet and D2 feet
5 digital pins can be configured separately for write / read / interrupt / pwm / I2C / one-wire supported
1 AD input
Integrated 18650 battery charge and discharge system
Micro USB input
Arduino compatible
NodeMCU compatible
Wide voltage input range 5V ~ 12V
1 switch can control whether the 18650 power supply
1 programmable LED (D0)
Charge protection
Discharge protection
if you plan to burn program to this board and please read below before you did it.
Please do not burn the program during the charging process.
When you burn the program, please unplug the battery and confirm that the switch is in the ON position
Note: This product DOES contain 18650 battery ONLY FROM US to thank our customers support
, please install the battery correct direction and it can not be reversed, otherwise you will burn the charging chip and you have to take responisble for this action. we tested all the board before ship to you so we are sure that it is 100% at working state.
Charging recommended to use 5V 500MA charger for charging, 5V 1A above will have fever, does not affect the normal work, but the charging process do not touch the charging chip or carry, the actual charge when the chip and the diode will rise to about 60 degrees, the normal work Will not heat, rest assured to carry.
Your Package Included
:
1 x
WiFi Deauther + Ready To Go +
1 BAT
Mount +
0.96" OLED
+
Joystick
V 2.0.5
PRE-FLASHED
1 x
1 BATTERY
1 x pins